On mgcoge3ne we also want to start the test application if the testpin
is asserted. But we don't have a full POST test support yet. So simply
add a function to read the testpin value.
Signed-off-by: Holger Brunck <holger.brunck@keymile.com>
Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com>
 
 #if defined(CONFIG_POST)
        testpin = post_hotkeys_pressed();
-       s = getenv("test_bank");
 #endif
+#if defined(CONFIG_MGCOGE3NE)
+       testpin = get_testpin();
+#endif
+       s = getenv("test_bank");
        /* when test_bank is not set, act as if testpin is not asserted */
        testboot = (testpin != 0) && (s);
        if (verbose) {
 
 int fpga_reset(void);
 int toggle_eeprom_spi_bus(void);
 
+int get_testpin(void);
+
 int set_km_env(void);
 int fdt_set_node_and_value(void *blob,
                        char *nodename,
 
        return 0;
 }
 #endif /* defined(CONFIG_OF_BOARD_SETUP) && defined(CONFIG_OF_LIBFDT) */
+
+#if defined(CONFIG_MGCOGE3NE)
+int get_testpin(void)
+{
+       /* Testpin is Port C pin 29 - enable = low */
+       int testpin = !get_pin(0x00000004, 2);
+       return testpin;
+}
+#endif