powerpc/km8321: define CONFIG_SYS_DDRCDR

On the km8321 boards is CONFIG_SYS_DDRCDR not defined, which leads to
the DDRCDR not being configured at startup and still containing the
reset value.

The required settings for our km8321 hardware designs are different than
the reset value and must be set with CONFIG_SYS_DDRCDR, that is used
by mpc83xx's cpu_init_f function at early CPU initialization.

The important settings are the DDR2 internal voltage level and the
half-strength "drivers".

In our case where the DRAM chips are soldered on board and the routing
for these signals under control, half-strength is sufficient as a few
measurements done in the lasts have shown. Since all the hardware
qualification tests have been performed with half strength, the nominal
strength settings are removed in favor of the default reset half
strength settings.

Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com>

diff --git a/include/configs/km/km8321-common.h b/include/configs/km/km8321-common.h
index cd563804929b5564967b96e60828038399f7ad89..ef83263e3d5f920da4dc01b761f1e22bb9d3cbba 100644 (file)
--- a/include/configs/km/km8321-common.h
+++ b/include/configs/km/km8321-common.h
@@ -64,6 +64,12 @@
        HRCWH_BIG_ENDIAN | \
        HRCWH_LALE_NORMAL)
 
+#define CONFIG_SYS_DDRCDR (\
+       DDRCDR_EN | \
+       DDRCDR_PZ_MAXZ | \
+       DDRCDR_NZ_MAXZ | \
+       DDRCDR_M_ODR)
+
 #define CONFIG_SYS_DDR_CS0_BNDS                0x0000007f
 #define CONFIG_SYS_DDR_SDRAM_CFG       (SDRAM_CFG_SDRAM_TYPE_DDR2 | \
                                         SDRAM_CFG_32_BE | \