mmc: zynq: Determine base clock frequency via clock framework

The zynq_sdhci controller driver use CONFIG_ZYNQ_SDHCI_MAX_FREQ as base
clock frequency but this clock is not fixed and depends on the hardware
configuration. Additionally the value of CONFIG_ZYNQ_SDHCI_MAX_FREQ
doesn't match the real base clock frequency of SDIO_FREQ. Use the clock
framework to determine the frequency at run time.

Signed-off-by: Stefan Herbrechtsmeier <stefan.herbrechtsmeier@weidmueller.com>
Reviewed-by: Jaehoon Chung <jh80.chung@samsung.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>

diff --git a/drivers/mmc/zynq_sdhci.c b/drivers/mmc/zynq_sdhci.c
index 69efa3857aab54c096bc331a69594a25de02be39..c73a4d3da09ce4d2c7de9f36a49991f20e7e1936 100644 (file)
--- a/drivers/mmc/zynq_sdhci.c
+++ b/drivers/mmc/zynq_sdhci.c
@@ -6,6 +6,7 @@
  * SPDX-License-Identifier:    GPL-2.0+
  */
 
+#include <clk.h>
 #include <common.h>
 #include <dm.h>
 #include <fdtdec.h>
@@ -27,8 +28,29 @@ static int arasan_sdhci_probe(struct udevice *dev)
        struct arasan_sdhci_plat *plat = dev_get_platdata(dev);
        struct mmc_uclass_priv *upriv = dev_get_uclass_priv(dev);
        struct sdhci_host *host = dev_get_priv(dev);
+       struct clk clk;
+       unsigned long clock;
        int ret;
 
+       ret = clk_get_by_index(dev, 0, &clk);
+       if (ret < 0) {
+               dev_err(dev, "failed to get clock\n");
+               return ret;
+       }
+
+       clock = clk_get_rate(&clk);
+       if (IS_ERR_VALUE(clock)) {
+               dev_err(dev, "failed to get rate\n");
+               return clock;
+       }
+       debug("%s: CLK %ld\n", __func__, clock);
+
+       ret = clk_enable(&clk);
+       if (ret && ret != -ENOSYS) {
+               dev_err(dev, "failed to enable clock\n");
+               return ret;
+       }
+
        host->quirks = SDHCI_QUIRK_WAIT_SEND_CMD |
                       SDHCI_QUIRK_BROKEN_R1B;
 
@@ -36,9 +58,9 @@ static int arasan_sdhci_probe(struct udevice *dev)
        host->quirks |= SDHCI_QUIRK_NO_HISPD_BIT;
 #endif
 
-       host->max_clk = CONFIG_ZYNQ_SDHCI_MAX_FREQ;
+       host->max_clk = clock;
 
-       ret = sdhci_setup_cfg(&plat->cfg, host, 0,
+       ret = sdhci_setup_cfg(&plat->cfg, host, CONFIG_ZYNQ_SDHCI_MAX_FREQ,
                              CONFIG_ZYNQ_SDHCI_MIN_FREQ);
        host->mmc = &plat->mmc;
        if (ret)