]> git.sur5r.net Git - u-boot/shortlog
u-boot
2018-03-31 Andre Heidercmd: cbfs: fix reading the end_of_rom pointer for 64bit...
2018-03-31 Kever Yangpinctrl-uclass: convert to use live dt
2018-03-31 Kever Yangcore: add uclass_get_device_by_phandle_id() api
2018-03-25 Tom RiniMerge git://git.denx.de/u-boot-ubi
2018-03-25 Tom RiniMerge git://git.denx.de/u-boot-spi
2018-03-25 Tom RiniMerge git://git.denx.de/u-boot-i2c
2018-03-25 Tom RiniMerge tag 'xilinx-for-v2018.05' of git://git.denx.de...
2018-03-24 Petr VorelConvert CONFIG_UBI_SILENCE_MSG to Kconfig
2018-03-24 Petr VorelConvert CONFIG_UBIFS_SILENCE_MSG to Kconfig
2018-03-24 Petr Vorelubifs: Reintroduce using CONFIG_UBIFS_SILENCE_MSG
2018-03-23 Sjoerd Simonsomap3: spi: Correct ti, pindir-d0-out-d1-in parsing
2018-03-23 Tom RiniMerge git://git.denx.de/u-boot-arc
2018-03-23 Eugeniy PaltsevARC: bootm: Refactor GO and PREP subcommands implementation
2018-03-23 Michal SimekMAINTAINERS: Fix Zynq/ZynqMP and Microblaze fragments
2018-03-23 Michal Simektools: xilinx: Fix zynq/zynqmp image recognition
2018-03-23 Siva Durga... arm64: zynqmp: Add support for verifying secure images
2018-03-23 Michal Simekarm64: zynqmp: Remove ep108 board
2018-03-23 Siva Durga... arm64: zynqmp: Correct EG/EV part detection logic
2018-03-23 Vipul Kumararm64: zynqmp: Print the value of pl clocks and wdt...
2018-03-23 Vipul Kumararm64: zynqmp: nand: Fixed NAND erase issue for size...
2018-03-23 Michal Simekarm: zynq: Remove OF_EMBED configuration for zc770...
2018-03-23 Michal Simekarm: zynq: Setup the same bootcommand as for zc770...
2018-03-23 Vipul Kumararm64: zynqmp: Changed scratch address used by the...
2018-03-23 Michal Simekarm: zynq: Enable cadence driver on zc706
2018-03-23 Michal Simekarm: zynq: Wire watchdog internals
2018-03-23 Shreenidhi... watchdog: Add Cadence watchdog driver
2018-03-23 Michal Simekclk: zynq: Show watchdog clock rate properly
2018-03-23 Michal Simekarm64: zynqmp: Enable newer pmufw versions
2018-03-23 Siva Durga... net: zynq_gem: Dont run any phy detection logic for...
2018-03-23 Nitin Jainarm64: zynqmp: Add support to load an app at EL1
2018-03-23 Siva Durga... arm: zynq: Enable debug uart on Zedboard
2018-03-23 Michal Simekarm64: zynqmp: Enable ethernet driver for zc1751-dc5
2018-03-23 Michal Simekfpga: Simplify error path in fpga_add
2018-03-23 Michal Simekxilinx: Sync defconfigs with latest Kconfig updates
2018-03-23 Michal Simekarm64: zynqmp: Convert board to use zynqmp-clk driver
2018-03-23 Heinrich Schuchardti2c: lpi2c: remove superfluous assignments
2018-03-22 Tom RiniMerge git://git.denx.de/u-boot-net
2018-03-22 Lokesh Vutlaconfigs: omapl138: Enable DM and DT
2018-03-22 Lokesh VutlaARM: dts: da850-lcdk: Sync from Linux 4.16
2018-03-22 Lokesh Vutladavinci: Enable DDR_INIT for DA8XX
2018-03-22 Faiz Abbasconfigs: am335x_evm: Increase SPL_SYS_MALLOC_F_LEN...
2018-03-22 Faiz Abbasgpio: omap_gpio: Add DM_FLAG_PRE_RELOC flag
2018-03-22 Luca Ceresoliscripts/check-config.sh: fix "command not found" error...
2018-03-22 David Lechnerdavinci: omapl138_lcdk: fix PLL0 frequency
2018-03-22 Liam Beguintest/py: add spi_flash tests
2018-03-22 Tuomas Tynkkynennet: Drop CONFIG_ENC28J60
2018-03-22 Heinrich Schuchardtnet: macb: remove superfluous logical constraint
2018-03-22 Heinrich Schuchardtdrivers: net: cpsw: remove superfluous assignment.
2018-03-22 Alexander Graflan7xxx: Require phylib
2018-03-22 Alexander Grafnet: Only access network devices after init
2018-03-22 Leonid Iziumtsevnet: Fix netretry condition
2018-03-22 Priyanka Jainnet/phy/cortina: Add No firmware upload option
2018-03-22 Priyanka Jainnet/phy/cortina.c: Update get_phy_id implementation
2018-03-22 Calvin Johnsonconfigs: ls1012a: add pfe configuration for LS1012A
2018-03-22 Calvin Johnsonarmv8: layerscape: csu: enable ns access to PFE registers
2018-03-22 Calvin Johnsonarmv8: fsl-lsch2: configure pfe's DDR and HDBUS interfa...
2018-03-22 Calvin Johnsonarmv8: fsl-lsch2: add pfe macros and update ccsr_scfg...
2018-03-22 Calvin Johnsonboard: freescale: ls1012a2g5rdb: enable network support...
2018-03-22 Calvin Johnsonboard: freescale: ls1012ardb: enable network support...
2018-03-22 Calvin Johnsonboard: freescale: ls1012afrdm: enable network support...
2018-03-22 Calvin Johnsonboard: freescale: ls1012aqds: enable network support...
2018-03-22 Calvin Johnsondrivers: net: pfe_eth: LS1012A PFE headers
2018-03-22 Calvin Johnsondrivers: net: pfe_eth: provide pfe commands
2018-03-22 Calvin Johnsondrivers: net: pfe_eth: LS1012A PFE driver introduction
2018-03-22 Prabhakar Kushwahaarmv8: fsl-layerscape: Add support of GPIO structure
2018-03-22 Calvin Johnsondrivers: net: phy: Fix aquantia compilation with DM
2018-03-22 Heinrich Schuchardtnet: mvpp2x: add check after calloc
2018-03-22 kevans@FreeBSD.orgConfigs: Use the newly added PHY_RTL8211E_PINE64_GIGABI...
2018-03-22 kevans@FreeBSD.orgnet: phy: Add PHY_RTL8211E_PINE64_GIGABIT_FIX for realt...
2018-03-22 Eugeniy PaltsevDW SPI: use 32 bit access instead of 16 and 32 bit mix
2018-03-22 Eugeniy PaltsevDW SPI: add option to use external gpio for chip select
2018-03-22 Eugeniy PaltsevDW SPI: refactor poll_transfer functions
2018-03-22 Eugeniy PaltsevDW SPI: fix transmit only mode
2018-03-22 Eugeniy PaltsevDW SPI: fix tx data loss on FIFO flush
2018-03-22 Liam Beguintest/py: add generic CRC32 function
2018-03-22 Liam Beguintest/py: do not import pytest multiple times
2018-03-22 Liam Beguintest/py: README: add HOSTNAME to PYTHONPATH
2018-03-22 Liam Beguintest/py: README: fix typo
2018-03-22 Liam Beguincmd: sf: fix map_physmem check
2018-03-22 Liam Beguinspi: spi_flash: do not fail silently on bad user input
2018-03-22 Tuomas Tynkkynentools: Make kwboot build if HOST_TOOLS_ALL=y
2018-03-21 Tom RiniMerge git://git.denx.de/u-boot-mips
2018-03-21 Álvaro Fernández... mips: bmips: add ar-5315 usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6318 usb
2018-03-21 Álvaro Fernández... phy: add support for bcm6318 usbh phy
2018-03-21 Álvaro Fernández... mips: bmips: add vr-3032u usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm63268 usb
2018-03-21 Álvaro Fernández... mips: bmips: add dgnd3700v2 usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6362 usb
2018-03-21 Álvaro Fernández... mips: bmips: add ar-5387un usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6328 usb
2018-03-21 Álvaro Fernández... mips: bmips: add wap-5813n usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6368 usb
2018-03-21 Álvaro Fernández... phy: add support for bcm6368 usbh phy
2018-03-21 Álvaro Fernández... mips: bmips: add nb4-ser usb support
2018-03-21 Álvaro Fernández... mips: bmips: add hg556a usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6358 usb
2018-03-21 Álvaro Fernández... phy: add support for bcm6358 usbh phy
2018-03-21 Álvaro Fernández... mips: bmips: add ct-5361 usb support
2018-03-21 Álvaro Fernández... mips: bmips: add support for bcm6348 usb
next