]> git.sur5r.net Git - u-boot/shortlog
u-boot
2012-07-18 Tom Riniehci-omap: Do not call dcache_off from omap_ehci_hcd_init
2012-07-18 Wolfgang DenkMerge branch 'next' of git://git.denx.de/u-boot-video
2012-07-18 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-nios
2012-07-16 Thomas Chounios2: move gd and bd into BSS
2012-07-13 Jerry HuangFSL/eSDHC: enable the clock to detect the SD card
2012-07-13 Jerry HuangSD/MMC: check the card status during erase operation
2012-07-13 Łukasz Majewskimmc:fix Call mmc_init() when executing mmc_get_dev()
2012-07-13 Jaehoon Chungmmc: remove the hard setting for tran_speed
2012-07-13 Eric Nelsoni.MX: fsl_esdhc: allow use with cache enabled.
2012-07-12 Tetsuyuki Kobayashinet: nfs: make NFS_TIMEOUT configurable
2012-07-12 Wolfgang DenkMerge branch 'next' of git://git.denx.de/u-boot-net...
2012-07-12 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-i2c
2012-07-11 Joe Hershbergernet: Inline the new eth_setenv_enetaddr_by_index function
2012-07-11 Rob Herringnet: allow setting env enetaddr from net device setting
2012-07-11 Dinh Nguyennet/designware: Consecutive writes to the same register...
2012-07-11 Marek VasutCACHE: net: asix: Fix asix driver to work with data...
2012-07-11 Troy Kiskynet: phy: micrel: make ksz9021 phy accessible
2012-07-11 Timur Tabinet: abort network initialization if the PHY driver...
2012-07-11 Timur Tabiphylib: phy_startup() should return an error code on...
2012-07-11 Jayachandran... net: tftp: fix type of block arg to store_block
2012-07-11 Fabio Estevammx28evk: Add I2C support
2012-07-11 Torsten Fleischermxs-i2c: Fix internal address byte order
2012-07-11 Troy Kiskymxc_i2c: remove setting speed at each start
2012-07-11 Troy Kiskymx6qsabrelite: add i2c support
2012-07-11 Troy Kiskymxc_i2c: specify i2c base address in config file
2012-07-10 Mike Frysingernet: fix typo in arp clean up
2012-07-10 Nobuhiro Iwamatsunet/sh-ether: Fix build by removing ECSIPR_BRCRXIP...
2012-07-10 Michal Simekmicroblaze: intc: Clear interrupt code
2012-07-10 Michal Simekmicroblaze: Call serial multi initialization
2012-07-10 Michal Simekmicroblaze: Move __udelay implementation
2012-07-10 Michal Simekmicroblaze: Remove extern from board.c
2012-07-10 Eric Nelsonipu_common: Add ldb_clk for use in parenting the pixel...
2012-07-10 Fabio Estevamipu_common: Do not hardcode the ipu_clk frequency
2012-07-10 Fabio Estevamipu_common: Rename MXC_CCM_BASE
2012-07-10 Fabio Estevamipu_common: Let clk_ipu_enable/disable only run on...
2012-07-10 Fabio Estevamipu_common: Only apply the erratum to MX51
2012-07-10 Fabio Estevamvideo: Rename CONFIG_VIDEO_MX5
2012-07-10 Fabio Estevammx6: Allow mx6 to access the IPUv3 registers
2012-07-10 Nikita Kiryanovcommon lcd: minor coding style changes
2012-07-10 Stephan Linzmicroblaze: Wire up dts configuration
2012-07-10 Stephan Linzfdt: Add board specific dts inclusion
2012-07-10 Wolfgang DenkPrepare v2012.07-rc1 v2012.07-rc1
2012-07-10 Wolfgang DenkMinor Coding Style cleanup
2012-07-10 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-arm
2012-07-10 Rajeshwari... EXYNOS: Fix USB compiler warning
2012-07-09 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-usb
2012-07-09 Stephen Warrentegra: define fdt_load/fdt_high variables
2012-07-09 Stephen Warrentegra: enable bootz command
2012-07-09 Jim Lintegra: usb: Fix device enumeration problem of USB1
2012-07-09 Stephen Warrentegra: trimslice: set up serial flash pinmux
2012-07-09 Stephen Warrentegra: add pin_mux_spi() board initialization function
2012-07-09 Stephen Warrentegra: add GMC/GMD funcmux entry for SFLASH
2012-07-09 Stephen Warrentegra: bootcmd: start USB only when needed
2012-07-09 Stephen Warrentegra: bootcmd enhancements
2012-07-09 Stephen Warrentegra: add enterrcm command
2012-07-09 Stephen Warrentegra: enable CONFIG_ENV_VARS_UBOOT_CONFIG
2012-07-09 Stephen WarrenAdd env vars describing U-Boot target board
2012-07-09 Lucas Stachtegra: usb: fix wrong error check
2012-07-09 Lucas Stachtegra: add ULPI on USB2 funcmux entry
2012-07-09 Tom Warrentegra: fix leftover CONFIG_TEGRA2_MMC & _SPI build...
2012-07-09 Thierry Redingtegra: Add Tamonten Evaluation Carrier support
2012-07-09 Thierry Redingtegra: Use SD write-protect GPIO on Tamonten
2012-07-09 Thierry Redingtegra: Implement gpio_early_init() on Tamonten
2012-07-09 Thierry Redingtegra: Allow boards to perform early GPIO setup
2012-07-09 Thierry Redingtegra: plutux: Add device tree support
2012-07-09 Thierry Redingtegra: medcom: Add device tree support
2012-07-09 Thierry Redingtegra: Rework Tamonten support
2012-07-09 Peter Meerwaldbeagle: add eeprom expansion board info for bct brettl4
2012-07-09 Rajeshwari... CONFIG: EXYNOS5: USB: Enable USB 2.0 on smdk5250
2012-07-09 Rajeshwari... EXYNOS5: USB: Fix incorrect USB base addresses
2012-07-09 Rajeshwari... EXYNOS: Add power Enable/Disable for USB-EHCI
2012-07-09 Rajeshwari... USB: EXYNOS: Set USB 2.0 HOST Link mode
2012-07-09 Rajeshwari... EXYNOS5: Add structure for PMU registers
2012-07-09 Rajeshwari... EXYNOS5: Fix system register structure
2012-07-09 Rajeshwari... USB: EXYNOS: Incorporate EHCI review comments
2012-07-09 Michal Simekmicroblaze: Move individual board linker scripts to...
2012-07-09 Michal Simekmicroblaze: Add gpio.h
2012-07-09 Stephan Linzmicroblaze: Add missing undefs for UBI and UBIFS
2012-07-09 Stephan Linzmicroblaze: Expand and correct configuration comments
2012-07-09 Wolfgang DenkRevert "arm: bugfix: save_boot_params_default accesses...
2012-07-09 Stephen Warrenfdt: send all dtc output to stderr
2012-07-08 Kim Phillipsext2fs: fix warning: 'blocknxt' may be used uninitialized
2012-07-08 Vladimir Yakovlevtools: Fix mingw tools build
2012-07-08 Kim Phillipsnet: make net_rand.h inclusion depend on BOOTP_RANDOM_DELAY
2012-07-08 Anatolij GustschinRemove remaining mdelay() macros
2012-07-08 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-arm
2012-07-08 Wolfgang DenkMerge branch 'master' of git://git.denx.de/u-boot-mpc85xx
2012-07-07 SRICHARAN RARM: cache: Move the cp15 CR register read before flush...
2012-07-07 Fabio EstevamARM: introduce arch_early_init_r()
2012-07-07 Marek VasutPXA: Enable CONFIG_PREBOOT on zipitz2
2012-07-07 Fabio EstevamARM: mx28: Remove CONFIG_ARCH_CPU_INIT
2012-07-07 Fabio EstevamNo need to define CONFIG_ARCH_CPU_INIT.
2012-07-07 esw@bus-elektronik.deadd new board vl_ma2sc
2012-07-07 Stefan RoeseMTD: SPEAr SMI: Add write support for length < 4 bytes
2012-07-07 Stefan Roesei2c: designware_i2c.c: Add support for the "i2c probe...
2012-07-07 Stefan Roesertc/m41t62: Add support for M41T82 with HT (Halt Update)
2012-07-07 Stefan RoeseSPL: ARM: spear: Add SPL support for SPEAr600 platform
2012-07-07 Stefan RoeseMakefile: Add u-boot.spr build target (SPEAr)
2012-07-07 Stefan RoeseSPL: ARM: spear: Remove some objects from SPL build
2012-07-07 Stefan RoeseSPL: lib/Makefile: Add crc32.c to SPL build
next