Add support for KARO TX25 board

[u-boot] / README

diff --git a/README b/README
index 8047c778887051693fda45a41be5c6b63b433aad..22e35c39bc4deaa553aa3eb226caef51c7ab2da8 100644 (file)
--- a/README
+++ b/README
@@ -777,7 +777,7 @@ The following options need to be configured:
                CONFIG_LBA48
 
                Set this to enable support for disks larger than 137GB
-               Also look at CONFIG_SYS_64BIT_LBA ,CONFIG_SYS_64BIT_VSPRINTF and CONFIG_SYS_64BIT_STRTOUL
+               Also look at CONFIG_SYS_64BIT_LBA.
                Whithout these , LBA48 support uses 32bit variables and will 'only'
                support disks up to 2.1TB.
 
@@ -846,20 +846,20 @@ The following options need to be configured:
                        Define this to use i/o functions instead of macros
                        (some hardware wont work with macros)
 
-               CONFIG_DRIVER_SMC911X
+               CONFIG_SMC911X
                Support for SMSC's LAN911x and LAN921x chips
 
-                       CONFIG_DRIVER_SMC911X_BASE
+                       CONFIG_SMC911X_BASE
                        Define this to hold the physical address
                        of the device (I/O space)
 
-                       CONFIG_DRIVER_SMC911X_32_BIT
+                       CONFIG_SMC911X_32_BIT
                        Define this if data bus is 32 bits
 
-                       CONFIG_DRIVER_SMC911X_16_BIT
+                       CONFIG_SMC911X_16_BIT
                        Define this if data bus is 16 bits. If your processor
                        automatically converts one 32 bit word to two 16 bit
-                       words you may also try CONFIG_DRIVER_SMC911X_32_BIT.
+                       words you may also try CONFIG_SMC911X_32_BIT.
 
 - USB Support:
                At the moment only the UHCI host controller is
@@ -2524,13 +2524,6 @@ use the "saveenv" command to store a valid environment.
 - CONFIG_SYS_FAULT_MII_ADDR:
                MII address of the PHY to check for the Ethernet link state.
 
-- CONFIG_SYS_64BIT_VSPRINTF:
-               Makes vsprintf (and all *printf functions) support printing
-               of 64bit values by using the L quantifier
-
-- CONFIG_SYS_64BIT_STRTOUL:
-               Adds simple_strtoull that returns a 64bit value
-
 - CONFIG_NS16550_MIN_FUNCTIONS:
                Define this if you desire to only have use of the NS16550_init
                and NS16550_putc functions for the serial driver located at