Merge branch 'master' of git://git.denx.de/u-boot-sunxi

[u-boot] / doc / README.falcon

diff --git a/doc/README.falcon b/doc/README.falcon
index 82a254b2e2565357a97a3479246023bbc02e3dbb..9a7f0bc23515089d1a5e8e968c7db58f051cb613 100644 (file)
--- a/doc/README.falcon
+++ b/doc/README.falcon
@@ -31,9 +31,10 @@ informed to load it before running the kernel.
 To boot the kernel, these steps under a Falcon-aware U-Boot are required:
 
 1. Boot the board into U-Boot.
-Use the "spl export" command to generate the kernel parameters area or the DT.
-U-Boot runs as when it boots the kernel, but stops before passing the control
-to the kernel.
+After loading the desired legacy-format kernel image into memory (and DT as
+well, if used), use the "spl export" command to generate the kernel parameters
+area or the DT.  U-Boot runs as when it boots the kernel, but stops before
+passing the control to the kernel.
 
 2. Save the prepared snapshot into persistent media.
 The address where to save it must be configured into board configuration
@@ -117,7 +118,12 @@ after each run of 'spl export'. Unfortunately the position of temporary
 storage can not be predicted nor provided at commandline, it depends
 highly on your system setup and your provided data (ATAGS or FDT).
 However at the end of an succesful 'spl export' run it will print the
-RAM address of temporary storage.
+RAM address of temporary storage. The RAM address of FDT will also be
+set in the environment variable 'fdtargsaddr', the new length of the
+prepared FDT will be set in the environment variable 'fdtargslen'.
+These environment variables can be used in scripts for writing updated
+FDT to persistent storage.
+
 Now the user have to save the generated BLOB from that printed address
 to the pre-defined address in persistent storage
 (CONFIG_CMD_SPL_NAND_OFS in case of NAND).