configs: Remove empty #ifdef/#ifndef blocks from configs

[u-boot] / include / configs / controlcenterd.h

diff --git a/include/configs/controlcenterd.h b/include/configs/controlcenterd.h
index 5e1f1b01395de45d9a52fa8295d67029760c5b2b..e5bf048398789f54a8075cb65062538988e4d9ae 100644 (file)
--- a/include/configs/controlcenterd.h
+++ b/include/configs/controlcenterd.h
@@ -35,15 +35,10 @@
 #endif
 
 /* High Level Configuration Options */
-#define CONFIG_BOOKE                   /* BOOKE */
-#define CONFIG_E500                    /* BOOKE e500 family */
-#define CONFIG_P1022
 #define CONFIG_CONTROLCENTERD
 #define CONFIG_MP                      /* support multiple processors */
 
-#define CONFIG_SYS_NO_FLASH
 #define CONFIG_ENABLE_36BIT_PHYS
-#define CONFIG_FSL_LAW                 /* Use common FSL init code */
 
 #ifdef CONFIG_PHYS_64BIT
 #define CONFIG_ADDR_MAP
@@ -60,7 +55,6 @@
 
 #ifdef CONFIG_TRAILBLAZER
 
-#define CONFIG_SYS_TEXT_BASE           0xf8fc0000
 #define CONFIG_RESET_VECTOR_ADDRESS    0xf8fffffc
 #define CONFIG_SYS_MONITOR_LEN         (256 * 1024)
 
@@ -78,7 +72,6 @@
 
 #else /* CONFIG_TRAILBLAZER */
 
-#define CONFIG_SYS_TEXT_BASE           0x11000000
 #define CONFIG_RESET_VECTOR_ADDRESS    0x1107fffc
 #define CONFIG_SYS_MONITOR_LEN         (512 * 1024)
 
@@ -126,8 +119,6 @@
 #define CONFIG_SYS_SDRAM_SIZE 1024
 #define CONFIG_VERY_BIG_RAM
 
-#define CONFIG_SYS_FSL_DDR3
-#define CONFIG_NUM_DDR_CONTROLLERS     1
 #define CONFIG_DIMM_SLOTS_PER_CTLR     1
 #define CONFIG_CHIP_SELECTS_PER_CTRL   (2 * CONFIG_DIMM_SLOTS_PER_CTLR)
 
@@ -143,7 +134,6 @@
 /*
  * Local Bus Definitions
  */
-#define CONFIG_FSL_ELBC                        /* Has Enhanced localbus controller */
 
 #define CONFIG_SYS_ELBC_BASE           0xe0000000
 #ifdef CONFIG_PHYS_64BIT
@@ -165,7 +155,6 @@
 /*
  * Serial Port
  */
-#define CONFIG_CONS_INDEX              2
 #define CONFIG_SYS_NS16550_SERIAL
 #define CONFIG_SYS_NS16550_REG_SIZE    1
 #define CONFIG_SYS_NS16550_CLK         get_bus_freq(0)
@@ -188,12 +177,8 @@
 #define CONFIG_SYS_FSL_I2C2_SLAVE      0x7F
 #define CONFIG_SYS_FSL_I2C2_OFFSET     0x3100
 
-#ifndef CONFIG_TRAILBLAZER
-#endif
-
 #define CONFIG_PCA9698                 /* NXP PCA9698 */
 
-#define CONFIG_CMD_EEPROM
 #define CONFIG_SYS_I2C_EEPROM_ADDR 0x52
 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 2
 
@@ -207,15 +192,9 @@
 #define CONFIG_SF_DEFAULT_MODE         0
 #endif
 
-#define CONFIG_SHA1
-
 /*
  * MMC
  */
-#define CONFIG_MMC
-#define CONFIG_GENERIC_MMC
-
-#define CONFIG_FSL_ESDHC
 #define CONFIG_SYS_FSL_ESDHC_ADDR      CONFIG_SYS_MPC85xx_ESDHC_ADDR
 
 #ifndef CONFIG_TRAILBLAZER
@@ -225,7 +204,6 @@
  */
 #define CONFIG_FSL_DIU_FB
 #define CONFIG_SYS_DIU_ADDR    (CONFIG_SYS_CCSRBAR + 0x10000)
-#define CONFIG_CMD_BMP
 
 /*
  * General PCI
@@ -235,7 +213,6 @@
 #define CONFIG_PCI_INDIRECT_BRIDGE
 #define CONFIG_PCI_SCAN_SHOW           /* show pci devices on startup */
 #define CONFIG_SYS_PCI_64BIT           /* enable 64-bit PCI resources */
-#define CONFIG_CMD_PCI
 
 #define CONFIG_FSL_PCI_INIT            /* Use common FSL init code */
 #define CONFIG_FSL_PCIE_RESET          /* need PCIe reset errata */
@@ -261,11 +238,8 @@
 /*
  * SATA
  */
-#define CONFIG_LIBATA
 #define CONFIG_LBA48
-#define CONFIG_CMD_SATA
 
-#define CONFIG_FSL_SATA
 #define CONFIG_SYS_SATA_MAX_DEVICE     2
 #define CONFIG_SATA1
 #define CONFIG_SYS_SATA1               CONFIG_SYS_MPC85xx_SATA1_ADDR
@@ -277,7 +251,6 @@
 /*
  * Ethernet
  */
-#define CONFIG_TSEC_ENET
 
 #define CONFIG_TSECV2
 
@@ -298,12 +271,9 @@
 
 #define CONFIG_ETHPRIME                "eTSEC1"
 
-#define CONFIG_PHY_GIGE                /* Include GbE speed/duplex detection */
-
 /*
  * USB
  */
-#define CONFIG_USB_EHCI
 
 #define CONFIG_HAS_FSL_DR_USB
 #define CONFIG_USB_EHCI_FSL
@@ -315,10 +285,8 @@
  * Environment
  */
 #if defined(CONFIG_TRAILBLAZER)
-#define CONFIG_ENV_IS_NOWHERE
 #define CONFIG_ENV_SIZE                0x2000          /* 8KB */
 #elif defined(CONFIG_RAMBOOT_SPIFLASH)
-#define CONFIG_ENV_IS_IN_SPI_FLASH
 #define CONFIG_ENV_SPI_BUS     0
 #define CONFIG_ENV_SPI_CS      0
 #define CONFIG_ENV_SPI_MAX_HZ  10000000
@@ -327,7 +295,6 @@
 #define CONFIG_ENV_OFFSET      0x100000        /* 1MB */
 #define CONFIG_ENV_SECT_SIZE   0x10000
 #elif defined(CONFIG_RAMBOOT_SDCARD)
-#define CONFIG_ENV_IS_IN_MMC
 #define CONFIG_FSL_FIXED_MMC_LOCATION
 #define CONFIG_ENV_SIZE                0x2000
 #define CONFIG_SYS_MMC_ENV_DEV 0
@@ -338,43 +305,14 @@
 /*
  * Command line configuration.
  */
-#ifndef CONFIG_TRAILBLAZER
-#define CONFIG_SYS_LONGHELP
-#define CONFIG_CMDLINE_EDITING                 /* Command-line editing */
-#define CONFIG_AUTO_COMPLETE                   /* add autocompletion support */
-#endif /* CONFIG_TRAILBLAZER */
 
 #define CONFIG_SYS_LOAD_ADDR   0x2000000       /* default load address */
-#ifdef CONFIG_CMD_KGDB
-#define CONFIG_SYS_CBSIZE      1024            /* Console I/O Buffer Size */
-#else
-#define CONFIG_SYS_CBSIZE      256             /* Console I/O Buffer Size */
-#endif
-/* Print Buffer Size */
-#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
-#define CONFIG_SYS_MAXARGS     16
-#define CONFIG_SYS_BARGSIZE    CONFIG_SYS_CBSIZE
 
 #ifndef CONFIG_TRAILBLAZER
-
-#define CONFIG_CMD_ERRATA
-#define CONFIG_CMD_IRQ
-#define CONFIG_CMD_REGINFO
-
 /*
  * Board initialisation callbacks
  */
-#define CONFIG_BOARD_EARLY_INIT_F
-#define CONFIG_BOARD_EARLY_INIT_R
 #define CONFIG_MISC_INIT_R
-#define CONFIG_LAST_STAGE_INIT
-
-#else /* CONFIG_TRAILBLAZER */
-
-#define CONFIG_BOARD_EARLY_INIT_F
-#define CONFIG_BOARD_EARLY_INIT_R
-#define CONFIG_LAST_STAGE_INIT
-
 #endif /* CONFIG_TRAILBLAZER */
 
 /*
@@ -383,7 +321,6 @@
 #define CONFIG_HW_WATCHDOG
 #define CONFIG_LOADS_ECHO
 #define CONFIG_SYS_LOADS_BAUD_CHANGE
-#define CONFIG_DOS_PARTITION
 
 /*
  * For booting Linux, the board info and command line data
@@ -398,24 +335,18 @@
  */
 
 #ifdef CONFIG_TRAILBLAZER
-
-#define CONFIG_BAUDRATE        115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
        "mp_holdoff=1\0"
 
 #else
 
-#define CONFIG_HOSTNAME                controlcenterd
+#define CONFIG_HOSTNAME                "controlcenterd"
 #define CONFIG_ROOTPATH                "/opt/nfsroot"
 #define CONFIG_BOOTFILE                "uImage"
 #define CONFIG_UBOOTPATH       u-boot.bin      /* U-Boot image on TFTP */
 
 #define CONFIG_LOADADDR                1000000
 
-
-#define CONFIG_BAUDRATE        115200
-
 #define        CONFIG_EXTRA_ENV_SETTINGS                               \
        "netdev=eth0\0"                                         \
        "uboot=" __stringify(CONFIG_UBOOTPATH) "\0"             \