2 # An autochanger device with two drives
8 Changer Command = "@scriptdir@/mtx-changer %c %o %S %a %d"
9 Changer Device = /dev/sg0
16 Archive Device = /dev/nst0
17 AutomaticMount = yes; # when device opened, read it
23 # Enable the Alert command only if you have the mtx package loaded
24 # Note, apparently on some systems, tapeinfo resets the SCSI controller
25 # thus if you turn this on, make sure it does not reset your SCSI
26 # controller. I have never had any problems, and smartctl does
27 # not seem to cause such problems.
29 Alert Command = "sh -c 'tapeinfo -f %c |grep TapeAlert|cat'"
30 If you have smartctl, enable this, it has more info than tapeinfo
31 Alert Command = "sh -c 'smartctl -H -l error %c'"
38 Archive Device = /dev/nst1
39 AutomaticMount = yes; # when device opened, read it
44 # Enable the Alert command only if you have the mtx package loaded
45 Alert Command = "sh -c 'tapeinfo -f %c |grep TapeAlert|cat'"
46 If you have smartctl, enable this, it has more info than tapeinfo
47 Alert Command = "sh -c 'smartctl -H -l error %c'"