- mailcommand = "@sbindir@/smtp -h @smtp_host@ -f \"\(Bacula\) %r\" -s \"Bacula: %t %e of %c %l\" %r"
- operatorcommand = "@sbindir@/smtp -h @smtp_host@ -f \"\(Bacula\) %r\" -s \"Bacula: Intervention needed for %j\" %r"
+#
+# NOTE! If you send to two email or more email addresses, you will need
+# to replace the %r in the from field (-f part) with a single valid
+# email address in both the mailcommand and the operatorcommand.
+# What this does is, it sets the email address that emails would display
+# in the FROM field, which is by default the same email as they're being
+# sent to. However, if you send email to more than one address, then
+# you'll have to set the FROM address manually, to a single address.
+# for example, a 'no-reply@mydomain.com', is better since that tends to
+# tell (most) people that its coming from an automated source.
+
+#
+ mailcommand = "@sbindir@/bsmtp -h @smtp_host@ -f \"\(Bacula\) \<%r\>\" -s \"Bacula: %t %e of %c %l\" %r"
+ operatorcommand = "@sbindir@/bsmtp -h @smtp_host@ -f \"\(Bacula\) \<%r\>\" -s \"Bacula: Intervention needed for %j\" %r"