For other drives and/or OSes, you will need to first ensure that your
system tape modes are properly setup (see below), then possibly modify
you Device resource depending on the output from the btape program (next
- item). When doing this, you should consult the \ilink{Storage Daemon
- Configuration}{StoredConfChapter} of this manual.
+ item). When doing this, you should consult the \borgxrlink{Storage Daemon
+ Configuration}{StoredConfChapter}{main}{chapter} of the \mainman{}.
\item If you are using a Fibre Channel to connect your tape drive to
Bacula, please be sure to disable any caching in the NSR (network
It isn't necessary to run the autochanger part of the test at this time,
but do not go past this point until the basic test succeeds. If you do
- have an autochanger, please be sure to read the \ilink{Autochanger
- chapter}{AutochangersChapter} of this manual.
+ have an autochanger, please be sure to read the \borgxrlink{Autochanger
+ chapter}{AutochangersChapter}{main}{chapter} of the \mainman{}.
\item Run the btape {\bf fill} command, preferably with two volumes. This
can take a long time. If you have an autochanger and it is configured, Bacula